Program Upload; Reset; Whites Setting; Whites Setting Factory Reset - Chauvet Colorado 1 Quad Zoom User Manual

O
PERATION

Program Upload

This option allows you to copy the custom programs of one Colorado 1 Quad Zoom onto other Colorado 1
Quad Zoom products by using the Master/Slave mode.
1. Configure and connect the products in a Master/Slave arrangement, where the master has the
custom programs you want to transfer to the slaves.
2. From the master, go to the SET main level.
3. Select UPLD
4. When PASS shows, press <ENTER>
5. Enter the master access passcode as shown in Passcode.
6. When SEND shows, press <ENTER> to start the upload.
7. Wait for the upload process to finish (the display will show END before continuing or turning the
products off.
The master and slaves will provide the status of the process by lighting up as
follows:
• Yellow indicates that the upload process is running.
• Green indicates that the upload process completed successfully.
• Red indicates that the upload process failed due to an error. Recheck all cable
connections and restart the process. If the issue persists, contact Chauvet
Technical Support.
DO NOT upload the data from a Colorado 1 Quad Zoom to a different product.
The other product may become inoperative.

Reset

This setting allows you to reset the Colorado 1 Quad Zoom to the default values including the custom
programs.
1. Go to the SET main level.
2. Select REST
3. When PASS shows, press <ENTER>.
4. Enter the master access passcode as described in Passcode.
5. Wait for the reset process to finish.

Whites Setting

This setting allows you to select and edit the temperature of the white colors used in channel 6 (Macros)
when in the TOUR and C1Q mode, channel 11 when in the TR16 and STD.Y mode, or channel 19 when in
the FULL mode.
1. Go to the CAL main level.
2. Enter the master access passcode as described in Passcode.
3. Go to CAL1.
4. Select a white color (WH.01-11).
5. Select a color (RED, GREN, BLUE, or WHIT).
6. Select a color value (000-255).
7. Repeat for the other colors..

Whites Setting Factory Reset

This setting allows you to reset to factory default the white colors used in channel 6 (Macros) when in the
TOUR and C1Q mode, channel 11 when in the TR16 and STD.Y mode, or channel 19 when in the FULL
mode.
1. Go to the CAL main level.
2. Enter the master access passcode as described in Passcode.
3. Go to CALR.
4. Enter the master access passcode as described in Passcode.

White Calibration

This setting allows you to select the white color shown by the Colorado 1 Quad Zoom when the color
setting is RGBW and the DMX controller's red, green, and blue faders are set to 255.
Colorado 1 Quad Zoom User Manual Rev. 1 Page 24 of 29