Faults And Troubleshooting - CARDIOSTRONG EX80-2 Assembly And Operating Instructions Manual

+ Check the tightness of all screw connections once a month.
+ In order to be able to guarantee the constructively defined safety level of this
equipment, we recommend having the equipment regularly maintained (at least
once a year) by specialists (service technicians of your contract partner).
+ The equipment may be cleaned of dust, dirt and sweat using a damp cloth. The
use of solvents should be strictly avoided. Also, make sure that no liquids (e. g.
sweat) get into the openings of the equipment (e. g. console).
2.2

Faults and Troubleshooting

The equipment runs through regular quality controls during production. Nevertheless,
errors or malfunctions on the equipment may occur. Individual parts are often the
cause of faults and replacement is usually sufficient. Please use the following overview
to see the six most common errors and how to repair them. If the equipment still does
not work properly, please contact your contract partner.
Problem
Drive discs wobble
or make noises
Display does not
work
Footplates are
creaking
Creaking noises
Guide rails are
squeaking
10
Cause
Drive pulley is loose
No plug connection,
power supply not
plugged in
Footplates are loose
Screws are loose
Guide rails or rollers are
dirty or the guide rails are
dry
Solution
Tighten nuts
Check all plug connections
and see if the power supply is
plugged in
Tighten up the footplate screws
Check screws are properly
tightened
Clean the guide rails, then
lubricate with a non greasy
silicone
EX80