Changing The Wiper Blades - Seat LEON Owner's Manual

Hide thumbs Also See for LEON:
Table of Contents

Advertisement

Make sure the battery clamps have sufficient
metal-to-metal contact with the battery termi-
nals.
If the engine fails to start after about 10 sec-
onds, switch off the starter and try again after
about 1 minute.
WARNING
Please note the safety warnings referring to
working in the engine compartment
›››
page
262.
The battery providing assistance must have
the same voltage as the flat battery (12V) and
approximately the same capacity (see imprint
on battery). Failure to comply could result in
an explosion.
Never use jump leads when one of the bat-
teries is frozen. Danger of explosion! Even af-
ter the battery has thawed, battery acid could
leak and cause chemical burns. If a battery
freezes, it should be replaced.
Keep sparks, flames and lighted cigarettes
away from batteries, danger of explosion.
Failure to comply could result in an explo-
sion.
Observe the instructions provided by the
manufacturer of the jump leads.
Do not connect the negative cable from the
other vehicle directly to the negative terminal
of the flat battery. The gas emitted from the
battery could be ignited by sparks. Danger of
explosion.
The essentials
Do not attach the negative cable from the
other vehicle to parts of the fuel system or to
the brake line.
The non-insulated parts of the battery
clamps must not be allowed to touch. The
jump lead attached to the positive battery
terminal must not touch metal parts of the ve-
hicle, this can cause a short circuit.
Position the leads in such a way that they
cannot come into contact with any moving
parts in the engine compartment.
Do not lean on the batteries. This could re-
sult in chemical burns.
Note
The vehicles must not touch each other, oth-
erwise electricity could flow as soon as the
positive terminals are connected.

Changing the wiper blades

Windscreen wipers service position
Wipers in service position
Fig. 79
The wiper arms can be raised when the wip-
›››
Fig.
ers are in service position
›››
Close the bonnet
page
Switch the ignition on and off.
Press the windscreen wiper lever down-
›››
page
26.
wards briefly
4
Before driving, always lower the wiper arms.
Using the windscreen wiper lever, the wind-
screen wiper arms return to their initial posi-
tion.
›››
page 87
79.
262.
63

Advertisement

Table of Contents
loading

Table of Contents