Lights And Visibility - Seat LEON Owner's Manual

Lights and visibility

Lights
Side light and dipped beam headlight
Read the additional information carefully
›››

page 24
The legal requirements regarding the use of
vehicle lights in each country must be ob-
served.
The driver is personally responsible for the
correct use and adjustment of the lights in all
situations.
Audible warnings to advise the driver that
the lights have not been switched off
If the key is not in the ignition and the driver
door is open, an audible warning signal is
heard in the following cases: this is a remind-
er to turn off the lights.
›››
● When the parking light is on
● When the light switch is in position  or
.
WARNING
The side lights or daytime running lights are
not bright enough to illuminate the road
ahead and to ensure that other road users are
able to see you.
Lights and visibility
Always use your dipped beam head lights if
●
it is raining or if visibility is poor.
WARNING
If the headlights are set too high and not
used correctly, there is a risk of dazzling or
distracting other road users. This could result
in a serious accident.
● Always make sure that the headlights are
correctly adjusted.
Daytime running lights
The daytime running lights consist of individ-
ual lights, integrated in the front headlights.
With the daylight driving lights on, only these
lights switch on
The daytime running lights switch on every
time the ignition is switched on, if the switch
is in positions  or , according to the level
of exterior lighting.
page 131.
When the light switch is in position , a
light sensor automatically switches dipped
beam on and off (including the control and
instrument lighting) or the daytime running
lights depending on the level of exterior
lighting.
›››
.
WARNING
● Never drive with daytime lights if the road
is not well lit due to weather or lighting con-
ditions. Daytime lights do not provide
enough light to illuminate the road properly
or be seen by other road users.
The rear lights do not come on with the
●
daytime driving light. A vehicle which does
not have the rear lights on may not be visible
to other drivers in the darkness, in the case
of heavy rain or in conditions of poor visibili-
ty.
Turn signal and main beam lever
Read the additional information carefully
›››

page 25
Push the lever all the way down to turn off
the corresponding function.
Convenience turn signals
For the convenience turn signals, move the
lever as far as possible upwards or down-
wards and release the lever. The turn signal
will flash three times.
The convenience turn signals are activated
and deactivated in the Easy Connect system
via the button and the
SETUP

›››
button page 110.
function
»
131