Seat LEON Owner's Manual page 108

● Second speed display
Speed warning function
●
● Start-Stop system status display
›››
page 191.
● Active cylinder management display
›››
® page 188
(ACT )*
● Signs recognised by the traffic signal de-
›››
page 222
tection system
● Low consumption driving status (ECO)
›››
page 106
● Identifying letters on engine (MKB).
Distance travelled
The odometer registers the total distance
travelled by the car.
The odometer ( trip ) shows the distance
travelled since the last odometer reset. The
last digit of the trip recorder indicates distan-
ces of 100 metres or one tenths of a mile.
● Briefly press the button
set the trip recorder to 0.
● Keep the button pressed for about 3
4
seconds and the previous value will be dis-
played.
Time
● To set the time, keep the button
pressed for more than 3 seconds to select
4
the hour or minute display.
106
›››

page 30. ● To continue setting the time, press the up-
per or lower part of the button
›››

page 37.
ton down to scroll through the numbers
quickly.
● Press the button
setting the time.
The time can also be set via the
and
SETUP
nect system
Compass
With the ignition on and the navigation sys-
tem on, the cardinal point corresponding to
the direction of travel of the vehicle is dis-
played on the instrument panel.
Selector lever position
The selected gear is displayed on the side of
the selector lever and on the instrument pan-
el display. In positions D and S, and with the
Tiptronic, the corresponding gear is also dis-
›››
Fig. 120 to re-
4
played.
Recommended gear (manual gearbox)
The recommended gear in order to save fuel
is displayed on the instrument panel while
you are driving
›››
Fig. 120
Second speed display (mph or km/h)
In addition to the speedometer, the speed
can also be displayed in a different unit of
measurement (in miles or in km per hour).
Operation
. Hold but-
4
again in order to finish
4
button

function button in the Easy Con-
›››
page 110.
›››

page 32.
This option cannot be deactivated in models
destined for countries in which the second
speed must always be visible.
The second speed display can be adjusted in
the Easy Connect system via the
and the function button
SETUP
Speed warning
When the speed setting is exceeded, this will
be indicated on the instrument panel display.
This is very useful, for example when using
winter tyres that are not designed for driving
at the maximum speed of the vehicle
›››

page 37.
The speed warning settings can be adjusted
in the Easy Connect system via the
and the function button
SETUP
Start-Stop operating display
Updated information relating to the status is
displayed on the instrument panel
›››
page 191.
Low consumption driving status (ECO)*
Depending on the equipment, when driving,
the " ECO " display appears on the instrument
panel when the vehicle is in low consump-
tion status due to active cylinder manage-
›››
® page 188.
ment (ACT )*
button

›››
page 110.
button

›››
page 110.