Cruise Control System (Ccs) - Seat LEON Owner's Manual

The Auto Hold function is automatically
turned off if the following conditions are
met:
Manual gearbox Automatic gearbox
If any of the conditions mentioned on
›››
page 194, Conditions for keeping the vehicle
1.
stationary with the Auto Hold function
ger met.
If the engine is running irregularly or an anomaly
2.
is detected.
If the engine is turned If the engine is switch-
3.
off or stalls.
The clutch and the ac-
If the accelerator is
4. celerator are pressed at
the same time.
If any of the tyres has
only minimal contact
5. with the ground, e.g. in
the case of axle articu-
WARNING
The smart technology incorporated into the
Auto Hold function cannot defy the laws of
physics; it only works within the limits of the
system. The greater convenience provided by
the Auto Hold function should never tempt
you to take any risk that may compromise
safety.
Never leave the vehicle running and with
●
the Auto Hold function switched on.
Driver assistance systems
The Auto Hold function cannot always keep
●
the vehicle stationary uphill or downhill or
stop it sufficiently, for example, on slippery
or frozen surfaces.
Note
Before entering a car wash, always switch off
are no lon-
the Auto Hold function, because if the elec-
tronic parking brake is automatically connec-
ted, it may cause damage.
ed off.

Cruise control system (CCS)*

Operation
pressed.
lation.
Instrument panel display: CCS status
Fig. 196
indications
Read the additional information carefully
›››

page 39
The cruise control system (CCS) is able to
maintain the set speed from 20 km/h (15
mph).
The CSS only reduces vehicle speed by ceas-
ing to accelerate, not by actively braking the
›››
vehicle .
Control lamp
When the warning lamp  is lit, cruise con-
trol is active.
Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
Displayed on the CCS screen
Status Fig. 196:
CCS temporarily switched off. The set
A
speed is displayed in small figures.
System error. Contact a specialised work-
B
shop.
CCS switched on. The speed memory is
C
empty.
The CCS is switched on. The set speed is
D
displayed in large figures.
»
195