Seat LEON Owner's Manual page 37

Menu Function
Distance Distance covered in km (m) after
covered switching on the ignition.
Whenever you refuel the quality of
the natural gas is automatically veri-
fied and is displayed when the igni-
tion is switched on. The display is
CNG quality
made in a percentage of between
70% and 100%. The greater the per-
centage displayed the lower the con-
sumption may be.
The average speed will be shown af-
ter a distance of about 100 metres
Average has been travelled. Otherwise hori-
speed zontal lines are displayed. The value
shown is updated approximately ev-
ery 5 seconds.
Digital dis-
Current speed displayed in digital
play of
format.
speed
If the stored speed is exceeded (be-
Speed warn-
tween 30 - 250 km/h, or 19 -
ing at ---
km/h or Speed 155 mph), an audible warning is
warning at given together with a visual warn-
--- mph ing.
Detection of
The traffic signs detected are dis-
traffic
played.
signs
Oil tempera- Updated engine oil temperature dig-
ture ital display
The essentials
Menu Function
Coolant tem-
Digital display of the current temper-
perature
ature of the liquid coolant.
gauge
a)
In vehicles with a natural gas engine, range and average con-
sumption refer only to data or natural gas consumption. If you
are in "petrol mode", the information of both data only appears
on the dash panel and not on the multifunction screen.
Storing a speed with the speed warning
● Select the display Speed warning at
--- km/h (--- mph)
Press the button on the windscreen
●

wiper lever or the button on the multifunc-

tion steering wheel to store the current speed
and activate the warning.
To switch system on: adjust to the desired
●
speed within 5 seconds using the rocker
switch on the windscreen wiper lever or

by turning the thumbwheel on the multifunc-
tion steering wheel. Next, press the button
or again or wait several seconds.
 
The speed is stored and the warning activa-
ted.
● To switch system off: press the but-
ton or . The stored speed is de-
 
leted.
Engine oil temperature display
Vehicles without multifunction steering
wheel
›››
● Press the rocker switch Fig. 42
the main menu appears. Enter into Driving
data . With the button move to the oil
2
temperature gauge.
Vehicles with multifunction steering wheel
Enter the submenu Driving data and
●
turn the thumbwheel until the oil tempera-
ture display appears.
The engine reaches its operating temperature
when in normal driving conditions, the oil
temperature is between 80°C (180°F) and
. If the engine is required to
120°C (250°F)
work hard and the outside temperature is
high, the engine oil temperature can in-
crease. This does not present any problem as
›››
long as the warning lamps

›››
page 41 or  table on page 41
appear on the display.
Additional electrical appliances
● Operation with the windscreen wiper lever*:
›››
Press the rocker switch Fig. 42
main menu appears. Enter into the section
. With the rocker switch,
Driving data
move to the display Convenience con-
sumers .
until
2
table on
do not
until the
2
»
35