Seat LEON Owner's Manual page 157

Removing the net partition
Fold the rear seat backrests forward.
●
● Press the left or right release catch
›››
Fig. 168 in the direction of the arrow
● Remove the casing from the support in the
›››
direction of the arrow Fig. 168
Fitting the net partition
Fold the rear seat backrests forward.
●
● Fit the casing in the right and left supports.
Press the casing into the left and right sup-
●
ports in the opposite direction to the arrow
›››
Fig. 168 until it engages.
2
The red markings on the release buttons
should no longer be visible.
WARNING
Always secure objects, even when the net
●
partition is properly assembled.
There should be nobody behind the assem-
●
bled partition when the vehicle is moving.
CAUTION
Incorrect handling of the net partition could
cause damage.
● Do not "release" the net partition when
lowering it, as the net and other vehicle parts
could be damaged. Roll down the net parti-
tion by hand.
Transport and practical equipment
Use of the net partition with the rear
seat backrests lowered
3 Applies to the model: LEON ST
.
1
.
2
Fig. 169 Assembling the net partition in the
rear seat backrests.
In the luggage compartment: net
Fig. 170
partition hooked into the rear seat backrests.
Fitting the net partition
● Fold the rear seat backrests forward.
● Remove the net partition from the side sup-
ports.
● Place the net casing in the rail slots in the
›››
Fig. 169
direction of the arrows
● Push the casing towards the left side of the
vehicle in the direction of arrow
and as far as it will go.
2
● Check that the net is secure.
Pulling out and securing the net partition
›››
Pull up handle Fig. 170
●
2
›››
net from the casing Fig. 170
Hook in the net partition on the right side
●
›››
Fig. 170 (magnified image).
3
● Hook in the net partition in the left side
›››
housing Fig. 170 pulling the rod.
1
The net partition is properly assembled when
the T-shaped ends are firmly secured in the
›››
Fig. 170
corresponding housings
.
1
Retracting the net partition
● Remove the rod from the housings in the
trims of the roof side members.
● Roll up the net into the casing
lowering it with your hand.
4
.
1
›››
Fig. 169
to remove the
.
4
and
3
›››
Fig. 170
»
155