Seat LEON Owner's Manual page 238

Standby position
Standby position: Position of the lev-
Fig. 228
er and the release bolt
Standby position adjusted properly
›››
Key Fig. 228 is in the released posi-
●
A
tion (the part of the key with the holes is fac-
ing upwards).
›››
● Lever Fig. 228 is in the bottom posi-
B
tion.
›››
● The release bolt
C
moved.
236
Thus adjusted, the detachable ball is ready
for installation.
CAUTION
The key cannot be removed or turned in the
standby position.
Assembling the detachable ball - Step
1
Fig. 229
bolt in the deployed position
Fitting the detachable ball
Remove the hook housing cap
●
›››
Fig. 225
Set the detachable ball to its standby posi-
●
›››
tion
Grip the detachable ball from below
Fig. 228 can be ●
›››
Fig. 229
Operation
Fitting the detachable ball / Release
4
downwards.
page 235.
and insert it into the hook hous-
ing following the direction of arrow
›››
engages audibly .
Lever turns automatically in the direction
A
of arrow upwards, and the release bolt
2
moves outwards (the red and green part will
›››
be visible) .
If lever does not turn automatically or the
A
release bolt does not come out, the de-
B
tachable ball should be removed by turning
the lever as far as possible downwards from
the housing cavity, and the detachable ball's
support surfaces and the cavity should then
be cleaned.
WARNING
● When attaching the detachable ball, keep
your hands well away from the reach of the
lever's rotation. There is a risk of injuring
your fingers!
● Never try to pull the lever upwards by force
to turn the key. The detachable ball would not
be secured properly!
until it
1
B