Interface Commands - KERN AEJ-C Operating Manual

29.4 Interface commands

The weighing balance recognises the commands listed below.
Commands
Function
Z Zeroing
T Taring
OT Query tare value
UT Set tare value
S Send stable weighing value in standard weighing unit
SI
Send weighing value immediately in standard weighing unit
SIA Send weighing values of all weighing pans in default weighing unit immediately
SU Send stable weighing value in current weighing value
SUI Send weighing value immediately in current weighing unit
C1
Start continuous output in standard weighing unit
C0 Stop continuous output in standard weighing unit
CU1 Start continuous output in current weighing unit
CU0 Stop continuous output in current weighing unit
DH Enter lower tolerance limit (tolerance weighing)
UH Enter upper tolerance limit (tolerance weighing)
ODH Query lower tolerance limit (tolerance weighing)
OUH
Query upper tolerance limit (tolerance weighing)
SM Enter reference single weight (parts counting)
TV Enter target weight (dosing)
RM Enter reference weight (percentage weighing)
Note
Enter serial number
K1 Disable device keyboard
K0 Enable device keyboard
SS Confirm / Press simulation "PRINT-key"
IC Start internal adjustment
IC1 Disable automatic internal adjustment
IC0 Enable automatic internal adjustment
OMI
List of available operating modes
OMS Set operating mode
OMG Query current operating mode
BP Confirm sound signal
PC Send all implemented commands
Finish commands with CR/LF character.
AEJ-C/AES-C/PLJ-C-BA-e-1621
157