KERN AEJ-C Operating Manual page 101

After setting the limit values, the weighing balance will be ready for check
weighing.

Tare, as required, place the load on the weighing pan and start tolerance
control.
The indicators <MIN>, <OK> or< MAX> will show the sample weight in relation
to the tolerance limits.
Sample display
• The limit values will be saved until new values are defined
• To delete limit values, set value to [0.000 g]
• Return to weighing mode, see chap. 17.2.1
AEJ-C/AES-C/PLJ-C-BA-e-1621
State
Load below set tolerance
Load within set tolerance
Load above set tolerance
101