Interface Commands - KERN AEJ 100-4DM Operating Manual

29.4 Interface commands

The weighing balance recognises the commands listed below.
Function
Commands
Z Zeroing
T Taring
OT Query tare value
UT
Set tare value
S Send stable weighing value in standard weighing unit
SI Send weighing value immediately in standard weighing unit
SIA
Send weighing values of all weighing pans in default weighing unit immediately
SU
Send stable weighing value in current weighing value
SUI Send weighing value immediately in current weighing unit
C1 Start continuous output in standard weighing unit
C0
Stop continuous output in standard weighing unit
CU1 Start continuous output in current weighing unit
CU0 Stop continuous output in current weighing unit
DH Enter lower tolerance limit (tolerance weighing)
UH
Enter upper tolerance limit (tolerance weighing)
ODH Query lower tolerance limit (tolerance weighing)
OUH Query upper tolerance limit (tolerance weighing)
SM
Enter reference single weight (parts counting)
TV
Enter target weight (dosing)
RM Enter reference weight (percentage weighing)
Note Enter serial number
K1
Disable device keyboard
K0 Enable device keyboard
SS Confirm / Press simulation "PRINT-key"
IC
Start internal adjustment
IC1
Disable automatic internal adjustment
IC0 Enable automatic internal adjustment
OMI List of available operating modes
OMS
Set operating mode
OMG Query current operating mode
BP Confirm sound signal
PC Send all implemented commands
Finish commands with CR/LF character.
AEJ-C/AES-C/PLJ-C-BA-e-1730 157