Removing The Bezel - Lenovo Flex System x480 X6 Compute Node Installation And Service Manual

Step 6. Carefully return the chassis to the bottom-side-down orientation.
Step 7. Install the I/O expansion adapters, if you removed them (see "Installing an I/O expansion adapter"
on page 1011).
Step 8. Install the air baffles.
Attention: Install the air baffles with the arrow indicating airflow direction pointing to the rear
of the compute node.
After you install the adapter-retention assembly, complete the following steps:
1. Install the cover onto the compute node (see "Installing the compute node cover" on page 988 for
instructions).
2. Install the compute node into the chassis (see "Installing a compute node in a chassis" on page 976
for instructions).

Removing the bezel

Use this information to remove the bezel.
Before you remove the bezel, read "Safety" on page v and "Installation guidelines" on page 973.
To remove the bezel, complete the following steps.
Left bezel
Right bezel
Step 1. Use a flat-blade screwdriver to carefully pull the bezel from the compute node.
Step 2. Lift the bezel from the compute node.
If you are instructed to return the bezel, follow all packaging instructions, and use any packaging materials
for shipping that are supplied to you.
Installing the bezel
Use this information to install the bezel.
Before you install the bezel, read "Safety" on page v and "Installation guidelines" on page 973.
To install the bezel, complete the following steps.
980
Lenovo Flex System x280 X6, x480 X6, and x880 X6 Compute Node Installation and Service Guide