Note: You might have to press the latch before you close the retention lever.
See "Configuring a RAID array" on page 41 for information about RAID configuration.
Removing the solid state drive cage and backplane
Use this information to remove the solid state drive cage and backplane.
Before you remove the solid state drive cage and backplane, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 973.
2. If the compute node is installed in a Lenovo Flex System chassis, remove it (see "Removing a compute
node from a chassis" on page 975 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
The solid state drive cage and backplane are available in the optional Flex System flash kit.
To remove the solid state drive cage and backplane, complete the following steps.
Solid state
drive cage
1022
Lenovo Flex System x280 X6, x480 X6, and x880 X6 Compute Node Installation and Service Guide
Solid state
drive backplane
Tabs