Lenovo Flex System x480 X6 Compute Node Installation And Service Manual page 1048

in the new system board (see "Removing a microprocessor and heat sink" on page 1027 and
"Installing a microprocessor and heat sink" on page 1030).
• Solid state drives (see "Installing a solid state drive" on page 1021).
• Solid state drive cage and backplane (see "Installing the solid state drive cage and backplane"
on page 1023).
• Solid state drive mounting sleeves (see "Installing the solid state drive mounting sleeve" on
page 1024).
• USB flash drives (see "Installing the USB flash drive" on page 1026).
Step 2. Install the left- and right-bezels (see "Installing the bezel" on page 980).
Step 3. The replacement system-board assembly comes with a Repair Identification (RID) tag. Using a fine
tip indelible ink pen, transfer the machine type and serial number from the defective system-board
assembly to the label on the Repair Identification tag; then, place the tag in the recessed area 1 on
the bottom of replacement system-board assembly.
After you install the components on the system board of the new base assembly, complete the following
steps:
1. Install the cover onto the compute node (see "Installing the compute node cover" on page 988 for
instructions).
1038
Lenovo Flex System x280 X6, x480 X6, and x880 X6 Compute Node Installation and Service Guide