Spark Plug Inspection And Replacement - Mercury 200 Verado FourStroke Operation And Maintenance Manual

a. Install the hub components in the sequence shown.
c
b
a
a - Propeller nut
b - Washer, 38 mm (1.5 in.) diameter
c - Belleville washer, 38 mm (1.5 in.) diameter
d - Thick washer, 46 mm (1‑13/16 in.) diameter
e - Propeller hub
b. Place a block of wood between the gearcase and the propeller.
Tighten the propeller nut to the specified torque.
Description
Propeller nut

Spark Plug Inspection and Replacement

1. Remove top and rear cowls. Refer to Cowl Removal and Installation.
2. Disconnect the wiring harness from the pencil coil connections.
3. Remove screws securing the coils.
4. Use a twisting motion, remove the pencil coils from the spark plugs.
a
a - Wiring harness connector
b - Pencil coil
c - Screw
eng
MAINTENANCE
d
e
Nm lb‑in.
75
b
c
57247
83
lb‑ft
– 55.3
58119