Mercury 200 Verado FourStroke Operation And Maintenance Manual page 101

Oil Drain Funnel
5. Remove the drain plug/seal washer and drain the engine oil into a
container.
6. Install the drain plug/seal washer.
CHANGING OIL FILTER
IMPORTANT: To reduce or prevent oil spillage when removing the oil filter,
ensure the outboard is upright (not tilted) and the engine is cold or has not run
for at least one hour.
1. Remove the top cowl.
2. Place a rag or towel below the oil filter to absorb any spilled oil.
3. Remove the old filter with an oil filter wrench tool by turning the filter
counterclockwise.
a
Oil Filter Wrench
4. Clean the oil filter mounting base.
5. Lubricate the new filter gasket with engine oil. Do not use grease.
6. Install the new filter until the gasket contacts the base, then tighten the
filter an additional 3/4 to 1 turn.
eng
MAINTENANCE
4993
a - Oil filter
57127
5221
91
91‑892866A01
Diverts draining engine oil from
contacting the antisplash and
anticavitation plates.
91‑889277
Aids in the removal of the oil filter.