Mercury 200 Verado FourStroke Operation And Maintenance Manual page 100

5. Insert the oil extraction tube into the oil dipstick hole until the tube is at the
bottom of the engine oil sump.
6. Pump the engine oil into an appropriate container.
Crankcase Oil Pump
DRAIN METHOD
IMPORTANT: The pump method is preferred to remove engine oil from XXL
models. If the drain method is used, an oil drain funnel must be used to divert
oil from the lower splash plate and into the container.
1. Tilt the outboard out/up past vertical for approximately one minute to allow
any trapped oil to drain back to the oil sump.
2. Place the outboard in a vertical position.
3. Place an appropriate container under the engine oil sump plug. The drain
plug/seal washer is located beneath the splash plate on the port side of
the outboard.
4. Loosen the drain plug/seal washer. Install the oil drain funnel over the
drain plug/seal washer.
b
MAINTENANCE
a
28778
Aids in the removal of engine oil without
draining the crankcase.
11591
a - Drain plug/seal washer
b - Oil drain funnel
90
91‑90265A 5
eng