Mercury 200 Verado FourStroke Operation And Maintenance Manual page 36

6. If the oil level is below the operating range (crosshatched region), remove
the oil filler cap and add approximately 500 ml (16 oz) of specified
outboard motor oil.
7. Tilt outboard out/up past vertical to allow trapped oil to drain back to the
oil sump. Allow outboard to remain tilted for approximately one minute.
8. Tilt the outboard to a vertical operating position and check the dipstick.
9. Repeat the process until oil level is on the operating range (crosshatched
region). Do not try to fill to the upper end of the operating range
(crosshatched region).
IMPORTANT: Inspect oil for signs of contamination. Oil contaminated with
water will have a milky color to it; oil contaminated with fuel will have a strong
fuel smell. If contaminated oil is noticed, have the engine checked by your
dealer.
10. Push the dipstick back in all the way.
11. Install the oil fill cap hand tight.
12. Install the top cowl.
FUEL AND OIL
26
28761
eng