Mercury 200 Verado FourStroke Operation And Maintenance Manual page 43

FEATURES AND CONTROLS
1. At the helm you are requesting be made active and with the ERC levers in
neutral, press the transfer button one time. After the transfer button is
pressed, the transfer button light turns on and one beep will sound
confirming the impending transfer.
NOTE: If the ERC levers at the helms are not in neutral, the neutral lights will
flash. Move all the ERC levers to neutral and the neutral light will stop flashing.
2. With the transfer button light and neutral light on, press the transfer button
a second time to complete the helm transfer.
3. When the helm transfer is complete, another beep sounds and the
transfer button light turns off.
NOTE: If the helm transfer is not completed in 10 seconds, the request is
automatically cancelled, a double beep sounds and control will remain at the
existing active helm. Press the transfer button again to start the helm transfer.
4. The helm where the transfer request was initiated, is now active and
controls the vessel.
THROTTLE-ONLY
Throttle‑only allows the operator to increase the engine RPM for warm‑up
without shifting the engine into gear. To engage throttle‑only mode:
1. Place the ERC lever in neutral.
2. Press the "Throttle‑Only" button. The button light will turn on and the
neutral lights will blink.
eng
DOCK
TRANSFER
THROTTLE - ONLY
"Transfer" button
DOCK TRANSFER
THROTTLE - ONLY
"Throttle-Only" button
33
52367
52373