Mercury 200 Verado FourStroke Operation And Maintenance Manual page 106

Tube Ref
Description
No.
High Performance
87
Gear Lubricant
Draining Gearcase
1. Place the outboard in a vertical operating position.
2. Remove the propeller. Refer to Propeller Replacement.
3. Place a pan below the gear housing to capture the lubricant.
4. Remove the lubricant level plug and fill/drain plug. Allow a sufficient
amount of time for the gearcase to drain. Depending on the ambient air
temperature, it may take 30 minutes for the gearcase to completely drain.
Filling the Gearcase
1. After the gearcase has been drained, fill the gearcase through the fill/drain
hole.
2. Add the specified gear lubricant.
IMPORTANT: Replace the sealing washers if damaged.
3. Allow a few minutes for the lubricant level to stabilize in the gearcase
before installing the lubricant level plug. Install the lubricant level plug.
4. Remove the tube and install the fill/drain plug.
5. Tighten the plugs to the specified torque.
Description
Plugs
Checking Lubricant Level
1. Place the outboard in a vertical operating position. Allow up to 30 minutes
for the lubricant level to stabilize in the gear housing.
MAINTENANCE
Where Used
Gearcase
a
b
57129
Nm
11.3
96
92-858064K01
a - Lubricant level plug
b - Fill/drain plug
lb‑in.
100
Part No.
lb‑ft
–
eng