Esc+K2 24×24 Dots Horizontal Writing Kanji - SATO S84EX Programming Reference Manual

41.1 Font
24×24 dots
ESC+K2
41.1
Horizontal Writing Kanji
Horizontal Writing Kanji
Hexadecimal ESC
code
<1B>
16
Initial value Nil
When the power switch is OFF
Valid range and
term of Valid range within item
command
Valid range between item
[Function]
Specifying horizontal writing Kanji font of W24 x H24 dots.
[Format]
<K2>an～n
●Parameter
a[Kanji specification mode] =
n[Data]
* Printing may not be correct when the number of data is increased/decreased.
[Coding Example] Specifying Hex character of Shift JIS, Horizontal enlargement scale: 3 times,
Vertical enlarged scale: 5 times (when KSX1001 is selected)
<A>
<V>100<H>200<P>2<L>0305
<K2> HB0A1B0A2B0A3B0A4B0A5
<Q>2
<Z>
[Notes]
1. Hexadecimal character
2. Binary code
3. Smoothing function enlargement scale
4. Highlight function enlargement scale
[Remarks]
1. In highlight function, the character width will increase based on the enlargement specification.
2. In highlight function, smearing problem may occur depending on the characters.
3. Printable fonts vary according to the font type. Make sure to check if it is printable or not before using.
[Valid Commands]
Print position <V>
Modification <P>
24×24
K2 Parameter
<4B> <32> an～n
16 16
The set parameter is not maintained.
The parameter preset will be invalid.
The parameter preset will be invalid.
H : Hexadecimal character
B : Binary code
I : Smoothing function by Hexadecimal character
C : Smoothing function by Binary code
J : Highlight function by Hexadecimal character
D : Highlight function by Binary code
K : Smoothing and highlight functions by Hexadecimal character
E : Smoothing and highlight functions by Binary code
= Specify according to the selected Kanji code range
= 4 bytes ASCII / 1 character
= 2 bytes / 1 character
= Horizontal/Vertical valid range: 3 to 12 times
= Horizontal/Vertical valid range: 1 to 5 times
<H>
<L> <%> <&>
dots
ESC+K2
</> <O> <WD>
66