Nikon A1 Instruction Manual page 83

Chapter 26. Capturing High-Speed ZT Series Images (Resonant Scanner)
(4) Click the
checking the image, and then click the
Note: Move the focus knob in the direction where the value of the plane in the cube increases.
(5) Click the
checking the image. Click the
Note: Move the focus knob in the direction where the value of the plane in the cube decreases.
(6) Determine [Step].
(7) Specify [A1 Piezo Z Drive] for [Z Device].
Note: The drive range of Piezo ZDrive is 100 μm (at ordinary temperature).
Set the total range to 100 μm or less.
Note: The drive range of Piezo ZDrive is approx. 50 μm at 37 degrees C.
1)-(4), (5)
Description about how to set the Z acquisition range of the ZT series without the perfect focus system is
finished.
Go to 26.4.
[Live] button and move the focus knob (fine motion mode) of the microscope while
[Live] button and move the focus knob (fine motion mode) of the microscope while
1)-(4)
1)-(5)
1)-(6)
1)-(7)
83
[Top] button to determine the top position.
[Bottom] button to determine the bottom position.
1)-(4), (5) Note
A1