RGBlink VENUS X1 User Manual page 36

->SENDING CARD SET
RECEIVING CARD SET
e. Turn the knob, select <RECEIVING CARD SET>, push the knob to confirm. Turn the knob
again, and select <CHOOSE CABLE>, push the knob to confirm. Turn the knob, select PORT
D1 and push the knob to confirm.
SENDING CARD SET
->RECEIVING CARD SET
->CHOOSE CABLE
HORIZONTAL CARD
VERTICAL CARD
WIDTH
f. Turn the knob, and select <Offset (A/B) Y>, push the knob to confirm. Turn the knob, set
Offset (A/B) Y as 240 (Note: Offset (A/B) Y=VERTICAL CARD×HEIGHT, in the previous part,
we set vertical card as 2 and height as 120). Shown as follows:
HEIGHT
Offset (A/B) X
->Offset (A/B) Y
CONNECT CARD TYPE
g. Turn the knob, and select <CONNECT CARD TYPE>, shown as follows:
HEIGHT
Offset (A/B) X
Offset (A/B) Y
->CONNECT CARD TYPE
Select the connection mode, the setting is same as Port U1. Then connection of both the
Port D and Port U of One Sending Card to LED Screen is finished.
Rendering is as follows:
VENUS X1
Chapter 3 : Using Your Product
>>
>>
>>
>>
PORT D
3
2
120
120
0
240
>>
120
0
240
>>
User Manual
35