Download  Print this page

Advertisement

Cisco TelePresence MX700 and MX800
Contents

Capturing snapshots

The snapshot feature, which is disabled by default, allows
snapshots captured by the video system to be displayed
on the Call Control page. Captures from the video system's
camera as well as from its presentation channel will be
displayed.
This feature might come in handy when administering the
video system from a remote location, e.g. to check the
camera view.
To use web snapshots you have to sign in with ADMIN
credentials.
Enabling the snapshot feature
The snapshot feature is disabled by default. The feature must
be enabled using the web
interface.
Web interface:
Go to the
Configuration
tab and select
Configuration
Navigate to
Video > AllowWebSnapshots
Click
Save
for the change to take effect.
Far end snapshots while in a call
While in a call, snapshots of the remote participant's main
camera and presentation channel (far end) will be captured
and displayed as shown in the illustration. The snapshots are
updated approximately every 30 seconds.
Far end snapshots are captured even if web
snapshots are disallowed on the far end video
system. Web snapshots are prohibited only for
encrypted calls.
D15119.02 MX700 and MX800 Administrator Guide TC7.2, AUGUST 2014.
Introduction
Web interface
Web interface
Navigate to: Call Control
System
and choose On.
System settings
Take live snapshots
While the
Live snapshots
box is checked,
snapshots are captured by the video
system (main source and presentation
source) approximately every two seconds.
Snapshots from the video system
23
Administrator Guide
Setting passwords
Click the snapshot in order
to see a larger image.
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
Appendices
Far end snapshots

Advertisement

Table of Contents

   Also See for Cisco TelePresence MX700

This manual is also suitable for:

Telepresence mx800

Comments to this Manuals

Symbols: 0
Latest comments: