Revert To The Previously Used Software Image - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

Revert to the previously used software image

Sign in to the web interface and navigate to
System Recovery.
D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016.
Configuration Peripherals
Maintenance > We recommend you to back up the log files and configuration
of the video system before you swap to the previously used
software image.
Back up log files and system configuration
1. Select the Backup tab.
2. Click
log files on your computer.
3. Click
instructions to save the configuration file on your computer.
Revert to the previously used software image
Only administrators, or when in contact with Cisco technical
support, should perform this procedure.
1. Select the Software Recovery Swap tab.
2. Click
software version.
3. Click
changed your mind.
Wait while the system resets. The system restarts automatically
when finished. This procedure may take a few minutes.
Maintenance Maintenance
Download Logs and follow the instructions to save the
Download Configuration Backup and follow the
Switch to software: cex.y.z..., where x.y.z indicates the
Yes to confirm your choice, or Cancel if you have
77
Administrator Guide
System settings
About the previously used
software image
If there is a severe problem with the video
system, switching to the previously used
software image may help solving the
problem.
If the system has not been factory reset
since the last software upgrade, the
previously used software image still
resides on the system. You do not have to
download the software again.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Appendices