Cisco TelePresence SX80 Administrator's Manual page 56

Cisco TelePresence SX80

Introduction
Set up the PresenterTrack feature
Step 1: Position the camera
Sign in to the web interface:
1. Navigate to Setup > Presenter Tracking.
2. Check the Enable PresenterTrack check box.
3. Click Configure... to open the configuration page.
When you click the Configure... button on the video
system's web interface, this will happen:
• Standby is deactivated.
• Full screen self-view is enabled.
• The trigger zone rectangle is shown on screen.
• If already active, the PresenterTrack feature is
deactivated.
Note that if you leave this web page at this stage,
without doing any changes, the trigger zone rectangle
is still visible on the video system's screen.
• If you are not in the room: Click the
remove the trigger zone rectangle on the screen.
• If you are in the room: Tap the
Touch controller and choose a camera position
from the list.
4. Choose a camera from the Camera source
A Precision 60 or SpeakerTrack 60 camera is required to
enable the PresenterTrack feature. If the camera does not
meet the requirements you will see a notification.
5. Define the stage area. Use the Touch controller to adjust
the full screen self-view (zoom, pan, tilt) if necessary.
The camera must cover the stage area that is used by
a presenter. When the presenter leaves the stage the
camera will stop following the presenter.
D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016.
Configuration Peripherals Peripherals
(page 2 of 5)
Save button to
Camera icon on the
drop down list.
Maintenance
Stage area: The zoomed out overview
image. Make it large enough so that
the presenter can move around. When
the presenter leaves the stage area
the tracking stops.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
56
Administrator Guide
System settings Appendices
Tip
• We recommend that you are in
the room when you configure the
PresenterTrack feature.
• Use the Touch controller to adjust the
camera (zoom, pan, tilt) to define the
stage area.
• Use the video system's web interface
to define the trigger zone. At the
same time, watch the screen of the
video system to see the result.
• Activate the PresenterTrack feature
from the camera panel on the Touch
controller.