Set Up The Snap To Whiteboard Feature - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

Set up the Snap to Whiteboard feature

The Snap to Whiteboard feature extends the speaker
tracking functionality, thus you need a camera that
supports SpeakerTrack:
• MX700 and MX800 with dual camera, or
• SX80 with SpeakerTrack 60 camera
Cameras > SpeakerTrack > Mode must be set to Auto,
and speaker tracking must be switched on with the Touch
controller.
With the Snap to Whiteboard extension, the camera
captures both the person and the whiteboard when a
person next to the whiteboard talks.
Without the Snap to Whiteboard extension, the camera
captures only the person.
D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016.
Configuration Peripherals Peripherals
(page 1 of 3)
Preparations
Whiteboard position
The whiteboard must be placed across the room from
the camera, as shown in the illustration.
When configuring the feature, you need to know
the accurate distance between the camera and the
whiteboard.
Maintenance
Speaker track camera
Accurate distance (d)
d between camera
and whiteboard
Whiteboard
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
52
Administrator Guide
System settings Appendices
Speaker position
The Sound tracking area is from half the whiteboard
and up.
Thus, the person presenting on the whiteboard must
stand upright next to the whiteboard. He or she
cannot move about in the room.
Sound
tracking
area