Cisco TelePresence SX80 Administrator's Manual page 79

Cisco TelePresence SX80

Introduction
Factory reset the video system
Factory reset using the shutdown button
We recommend that you back up the log files and configuration of
the video system before you continue with the factory reset.
1. Press and hold the shutdown button until the LEDs go out
(approximately 5 sec) and the system shuts down.
2. Press and hold the shutdown button until the power LED start
blinking (approximately 10 seconds). Then release the button.
3. Within four seconds after the LED starts blinking, press the
shutdown button twice to engage the factory reset.
4. Wait while the video system reverts to the default factory
settings. The video system restarts automatically when
finished. This may take a few minutes.
The video system confirms the factory reset by displaying a
notification on the main screen. The notification disappears
after approximately 10 seconds.
If you failed to press the shutdown button twice within
the four seconds, the system will not revert to the default
factory settings, and you will not see the confirmation
message. If this happens, go back to step 1 and try again.
D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016.
Configuration Peripherals
(page 2 of 2)
Shutdown
button
Maintenance Maintenance
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
79
Administrator Guide
System settings Appendices