Installation; Installation Precautions; Package & Storage - Barco RHDM-2301 User Manual

7.8 Installation

7.8.1 Installation precautions

• Keep the original packaging. It is designed for this unit and is the ideal protection
during transport.
• Allow adequate ventilation in case the configuration is built in a rack or a console, so
that the heat can dissipate properly.
• For units where the power cable or connector is the primary means of detaching the
system from the power supply. One of the cable ends (or power connector) should
be easily accessible.
• Make sure the unit is disconnected from mains before connecting the signals.
• The display unit must be earthed correctly, as described in the safety precautions
paragraph.
• Before connecting the unit to mains, check if the power source voltage corresponds
to the mains voltage marked on the identification label on the display.
7.8.2 Package & storage
7.8.2.1 General
A safe transport of the units can only be guaranteed if the original undamaged package is
used for shipping. Handle with care when transporting.
Keep your original packaging. It is designed for this unit and is the ideal protection during
transportation.
7.8.2.2 Procedure in case of damages
All shipments should be opened and inspected for concealed damage or pilferage as soon
as possible after the arrival at destination. The shipping cartons should be retained for
the surveyor's inspection and full and accurate reserves must be made by a letter or a fax
message.
Depending upon the used means of transport, the written protest is subject to different
time-rules:
• by sea: the protest has to be issued against the captain and/or ship within 3 days of
the delivery of the goods.
• by road: the protest has to be issued against the last road-carrier within 7 days after
delivery of the goods.
• by air: the protest has to be issued against the air-carrier within 14 days after deliv-
ery of the goods.
In all cases, a claim or potential claim should be reported as soon as possible whether or
not full documentation is immediately available.
After completion of all required steps, the claim should normally be finalized within one
month. For more information about the claims handling procedure, contact Barco n.v.
7.8.2.3 Storage
It is best to store the display unit in its original packaging in a room that does not exceed
the storage conditions mentioned in the technical specification.
Barco - RHDM-2301 - User manual ___________________________________________________ 133
Addendum