How To View Signals Connected To The Sdi Input Board - Barco RHDM-2301 User Manual

3.3 How to view signals connected to the SDI input board

INPUT 1
A1
IN OUT
Figure 10: Input connectors SDI input board
The standard input board that is mounted in slot 1 is a SDI input board. The SDI input
board has two inputs that are separately connected with a loop-through output connector.
:
NOTE
The input signals are not available at the loop-through output connectors when the display unit is in
hard standby (Power LED = orange).
Up to 2 inputs can be applied to the SDI board simultaneously. In the table below the
possible combinations are shown:
Input SDI board
Possible inputs
To select a valid signal, open the input selection toolbox by pressing long (
button of the window in which the input signal has to be shown
The concept of selection and viewing of the valid signals is summarized in the figure
below:
ACTIVE WINDOW
is shown on screen
Figure 11: Selection of inputs window 1 & 2
Barco - RHDM-2301 - User manual ____________________________________________________ 25
INPUT 2
B1
IN OUT
Input 1
SDI
HDSDI
3Gb/s (optional)
Dual link (optional)
WINDOW 1
press
WINDOW 2
Input 2
SDI
HDSDI
3Gb/s (optional)
press
INPUT 1
INPUT 2
press
INPUT 1
press
INPUT 2
How to
) on the
or .