Barco RHDM-2301 User Manual page 139

Figure 68: Rear side of the display unit with mounted tiltable stand
To change the setting of the stand, turn the knob on the right hand side of the stand
counter clockwise to loosen. Choose the new angle and turn the knob clockwise to fix the
stand to the new setting.
:
WARNING
Mind your fingers when tilting the display unit towards negative angles (limited space between control
panel and stand).
7.8.3.3 Control panel
Figure 69: Bottom view of the display unit with mounted control panel
The control panel is mounted at the bottom of the display unit and can be mounted and/
or removed easily.
To remove the control panel from the display unit:
• Place the display unit with the front side on a horizontal, flat and stable table, cov-
ered with bubble wrap or a similar protective material.
• Remove the Barco stand (if necessary)
• Unplug the cables that connect the control panel to the display unit.
• Remove the 4 screws that fix the control panel to the bottom of the display unit.
Store the screws at a safe place.
• Mount the Barco stand (if necessary)
Barco - RHDM-2301 - User manual ___________________________________________________ 139
Addendum