Barco RHDM-2301 User Manual page 137

VESA compatible mounting positions at the back side. The mounting positions are spaced
by 100mm horizontally and 100mm vertically (see figure above).
7.8.3.1.2 Remove the Barco stand
Instructions to remove the Barco stand from the display unit:
• Place the display unit with the front side on a horizontal, flat and stable table, cov-
ered with bubble wrap or a similar protective material.
• Unscrew the 4 knurled screws and remove the Barco stand. Keep the knurled screws
and the Barco stand in a safe place in case the Barco stand has to be installed again.
7.8.3.1.3 Install the Barco stand
Instructions to mount the Barco stand to the display unit:
• Place the display unit with the front side on a horizontal, flat and stable table, cov-
ered with bubble wrap or a similar protective material.
• Mount the Barco stand on the bottom 4 VESA mounting positions with the knurled
screws provided with the stand.
• Place the display unit up-right and verify that the display unit is placed on a flat and
horizontal surface at all times.
Figure 65: Mounting of Barco stand – screw location
Barco - RHDM-2301 - User manual ___________________________________________________ 137
Addendum