Fan Assembly, Card Cage; Fan Assembly, Hammerbank - Printronix P8000 SERIES Maintenance Manual

Fan Assembly, Card Cage

Removal
1. Prepare the printer for maintenance (page 178).
2. Cabinet Models: Remove the paper path (page 243).
Tabletop and Pedestal Models: Remove the electronics barrier panel
(page 237).
3. Disconnect the card cage fan cable connector P306. (See page 296.)
4. Cabinet Models: Remove the two fan mounting screws from the bottom of
the fan. (See page 296, item 2.)
Tabletop and Pedestal Models: Remove the four fan mounting screws
and nut. (See page 282, items 1 through 4.)
5. Remove the card cage fan assembly from the card cage.
Installation
CAUTION
Air flow is INTO the card cage. Install the card cage fan so the label
faces toward the inside of the printer and the cable faces the front of the
printer.
1. Reverse step 2 through step 5 of the removal procedure.
2. Return the printer to normal operation (page 179).

Fan Assembly, Hammerbank

Removal
1. Prepare the printer for maintenance (page 178).
2. Remove the ribbon. (Refer to the User's Manual.)
3. Remove the shuttle cover assembly (page 235).
4. Disconnect the fan cable connector P308 from J308 at the fan.
5. Remove the two screws securing the fan to the base casting. Angle the
hammerbank fan assembly up and out of the base casting and feed the
motor wires and cable connector out from between the base casting and
the base pan. (See page 296, items 21 and 22.)
Installation
CAUTION
Air flow is UP. Install the hammerbank fan so the label faces up.
1. Reverse step 2 through step 5 of the removal procedure.
2. Return the printer to normal operation (page 179).

Fan Assembly, Card Cage

239