Control Panel Assembly - Pedestal Model - Printronix P8000 SERIES Maintenance Manual

Control Panel Assembly - Pedestal Model

Removal
1. Prepare the printer for maintenance (page 178).
2. Open the printer cover.
3. Remove the four screws securing the panel bracket to the printer cover.
(See page 274, items 1, 2, and 3).
4. Remove the two screws securing the control panel to the panel bracket.
5. Remove the control panel cable from underneath the cable clamp.
6. Disconnect the ribbon cable connector P310 from the J310 on the back of
the control panel assembly. (See page 274, item 5).
7. Remove the control panel assembly from the panel bracket.
Installation
1. Engage the slot on the bottom of the control panel on the bottom edge of
the panel bracket cutout.
2. Align the holes on the top rear of the control panel with the holes in the
upper edge of the panel bracket, and install the two mounting screws.
3. Connect P310 to J310 on the back of the control panel.
4. Secure the control panel cable underneath the cable clamp.
5. Install the four screws securing the panel bracket to the printer.
(See page 274, items 1, 2, and 3).
6. Return the printer to normal operation (page 179).

Control Panel Assembly - Pedestal Model

231