Electronics Barrier Panel - Printronix P8000 SERIES Maintenance Manual

Electronics Barrier Panel

NOTE: This procedure applies to the pedestal models only.
CAUTION
Do not drop screws into the card cage.
Removal
1. Prepare the printer for maintenance (page 178).
2. Use a #2 Phillips screw driver to loosen the captive screws on both sides
of the lower paper path assembly. DO NOT remove the screws. (Figure 8,
page 280, item 12).
3. Loosen the screws on the back side of the lower paper path assembly.
DO NOT remove the screws. (Figure 8, page 280, item 13).
4. Slide the lower paper path assembly back, aligning it with the key hole,
and lift up to remove.
5. Loosen the captive screws on the electronics barrier panel, and using
both hands, lift panel up to remove. (Figure 8, page 280,
items 3 and 4).
Installation
IMPORTANT
Be sure to install the electronics barrier panel inbetween the side plate
and the card cage wall.
1. Reverse step 2 through step 5 of the removal procedure.
IMPORTANT
Make sure the electronics barrier panel grommet holes fit over the
grommets. Check cables for obstruction.
2. Return the printer to normal operation (page 179).

Electronics Barrier Panel

237