Summary; Storage And Handling - Printronix P8000 SERIES Maintenance Manual

Summary

Because it is impossible to test all possible forms available for use in the
printer, Printronix recommends that paper conform to the specifications
outlined in this appendix for the best printer performance.
But the guidelines in this appendix are not a substitute for actual testing.
Always test forms—including special single-part paper, multipart forms, forms
with glue strips, carbonless forms, card stock, and labels—for satisfactory
feeding, registration, and print quality prior to purchase. For best results in
selecting standard or specialty forms, consult a forms vendor who can ensure
conformance to the guidelines in this appendix and who can recommend cost-
effective purchases.

Storage and Handling

The performance of the printer depends to a large degree on the condition of
the paper used; therefore, the following principles for packaging, handling,
and storage are highly recommended.
Packaging
To avoid damage during handling, use top and bottom fillers in continuous
form cartons to hold the paper stack firmly in place. Proper packaging
ensures that the paper remains flat and is not damaged along the edges.
Storage
Do not store cartons directly on the floor, and do not stack them more than six
high. Set each carton upright and squarely on the one underneath. Do not
place anything else on the stack of paper, as this can damage the paper.
Preconditioning Forms
Protect paper from temperature and humidity extremes. Store paper in the
same environment as the printer for 24 to 48 hours before using the paper.
This allows the moisture content of the paper to stabilize.
P8000 printers are used at temperatures from 5
to 1524 meters (5000 feet), from 5
(8000 feet), with a non-condensing relative humidity of 10% to 90%. This is
the full operating range; for the best results store the printer paper at 18
°
24
If the printer is in an environment subject to extremes of temperature or
humidity, store the printer paper in a better environment and move it to the
printer as needed.
° °
C (65 to 75 F), with a relative humidity of 40% to 50%.
° °
to 40 C (41
° ° ° °
to 32 C (41 to 90 F) up to 2438 meters
° °
to 104 F) up
°
to
485