Vega VEGABAR 54 Operating Instructions Manual page 19

IP 68 version with remote
housing - Ex
VEGABAR 54 - 4 ... 20 mA/HART
Proceed as follows:
1 Loosen the screw in the cover of the plug connector and
remove it
2 Open the cover and remove it
3 Press the plug insert downwards
4 Loosen the screws of the strain relief and cable entry
1
3
Fig. 8: Plug connector with opened cover
1 Plug insert
2 Strain relief
3 Cable gland
4 Housing
5 Insert the connection cable through the cable entry and into
the plug housing
6 Connect the wire ends to the screw terminals acc. to the
wiring plan
The connection cable is already preconfectioned. If necessary shorten to
4)
the requested length, cut the breather capillaries clean. Remove approx.
5 cm of the cable mantle, strip approx. 1 cm insulation from the ends of the
individual wires. After shortening the cable, fasten the type plate with sup-
port back onto the cable.
Connecting to power supply
1
2
4
4)
2 3
19