Vega VEGABAR 54 Operating Instructions Manual page 17

IP 68 version with remote
housing - Non-Ex
VEGABAR 54 - 4 ... 20 mA/HART
9 Check the hold of the wires in the terminals by lightly
pulling on them
10 Connect the screen to the internal ground terminal and the
external ground terminal to potential equalisation
11 Tighten the compression nut of the cable entry, the seal
ring must completely encircle the cable
12 Screw the housing cover back on
The electrical connection is finished.
Fig. 6: Connection steps 6 and 7
Proceed as follows:
1 Loosen the four screws on the housing socket with an Allen
key size 4
2 Remove the mounting plate from the housing socket
Connecting to power supply
17