6.
On the Settings tab, set the emulation to VT100 and click OK.
Figure 29 Setting terminal emulation in Switch Properties dialog box
Powering on the switch
Before powering on the switch, confirm the following:
•
The switch has been steadily mounted.
All the cards have been correctly installed.
•
The unused slots have been installed with filler panels.
•
All the network cables, fibers, power cables, and grounding cables have been correctly connected.
•
The input power voltage meets the requirements of the switch.
•
•
The console cable has been correctly connected. The configuration terminal has been started, and
the terminal parameters have been set.
To power on the switch:
Turn on the power supply of the switch to power on the switch.
The following is a sample output you can see on the terminal:
System is starting...
Booting Normal Extend BootWare.
The Extend BootWare is self-decompressing...................................
.....Done!
****************************************************************************
36