Figure 18 Installing a power module
(1) Install the power module to the chassis
Connecting the power cable
WARNING!
Before connecting the power cable, make sure the circuit breaker on the power cable is switched off.
To connect the power cable:
1.
Plug the power cable into the power receptacle of the power module.
2.
Use a cable tie to secure the power cable to the cable management bracket, as shown in
19.
3.
Plug the other end of the power cable to the AC power receptacle of the power source and switch
on the circuit breaker.
4.
Verify the power module input status LED.
1
2
23
(2) Fasten the captive screw
Figure