Figure 53 Removing the grounding cable
(1) Grounding sign
(3) Loosen the hex nut on the grounding post of the grounding strip
3.
Put the grounding cable into the accessories box.
Removing the twisted pair and optical fiber
You must remove twisted pairs and optical fibers from all the interfaces of the switch.
NOTE:
After pulling out an optical fiber from an optical transceiver module, cover the connector of the optical
fiber with a dust cap to keep the connector clean.
Repackaging the switch accessories
Repackaging the power module
CAUTION:
Before removing a power module, switch off the circuit breakers at the input end of all power cables, and
remove all the power cables to avoid device damage and bodily injury.
Follow these steps to repackage a power module:
1.
Prepare the packing bag and box of the power module. Make sure the bag is clean, dry, and not
damaged.
2.
Remove all power modules from the chassis, and then install blank filler panels to the empty slots.
For how to remove a power module and install a blank filler panel, see "Replacement
procedures."
3.
Put the power module into the bag.
(2) Remove the grounding cable from the chassis
97