Installing An Air Filter (Optional); Mounting The Switch To The Rack - H3C S7508E-X Installation Manual

Figure 9 Installing the mounting brackets
1
(1) Screws for fixing the mounting brackets to the chassis
(3) Signal cable management brackets

Installing an air filter (optional)

Air filters of the S7508E-X switch are optional. If you have ordered air filters, install the air filters before
mounting the switch to the rack. The air filter is located at the left of the chassis. For the installation
procedures, see the Air Filter User Manual.

Mounting the switch to the rack

CAUTION:
Do not hold the handle of the fan tray, power module, or the back cover of the chassis, or the air vents
•
of chassis. Any attempt to carry the switch with these parts might cause equipment damage or even
bodily injury.
After placing the switch on the slide rails, do not leave go of your hands immediately because this might
•
tip the switch, damaging the switch or even causing bodily injury.
To mount the switch to the rack:
1. Move the chassis to face the rear of the chassis towards the front of the rack.
2. Use at least two people to lift the switch by using the handles or supporting the bottom of the
chassis until the bottom of the switch is a little higher than the slide rails on the rack.
H3C recommends using a mechanical lift for moving your switch.
3. Place the switch on the slide rails and slide the switch along the slide rails until the mounting
brackets on the switch touch the front rack posts, as shown in callout 1 on
3
2
3
2
(2) Mounting brackets
14
1
Figure 10.