Table of Contents
Advertisement
7.
Connect the RJ-45 connector of the cable to the console port of the switch.
Setting terminal parameters
To configure and manage the switch through the console port, you must run a terminal emulator
program, TeraTermPro or PuTTY, on your configuration terminal. You can use the emulator program
to connect a network device, a Telnet site, or an SSH site. For more information about the terminal
emulator programs, see the user guides for these programs
The following are the required terminal settings:
•
Bits per second—9600.
•
Data bits—8.
•
Stop bits—1.
•
Parity—None.
•
Flow control—None.
Powering on the switch
1.
Before powering on the switch, verify that the following conditions are met:
All the fan tray slots have a fan tray installed.
The liquid-cooled pipes and cables are connected correctly.
The power cords are connected correctly.
The input power voltage is as required by the switch.
The console cable is connected correctly.
The configuration terminal (a PC, for example) has started, and its serial port settings are
consistent with the console port settings on the switch.
2.
Power on the switch.
During the startup process, you can access BootWare menus to perform tasks such as
software upgrade and file management. The BootWare interface and menu options vary by
software version. For more information about BootWare menu options, see the
software-matching release notes for the device.
3.
After the startup completes, you can access the CLI to configure the switch.
For more information about the configuration commands and CLI, see H3C S6805 & S6825 &
S6850 & S9850 Switch Series Configuration Guides and H3C S6805 & S6825 & S6850 &
S9850 Switch Series Command References.
3-29
Advertisement
Table of Contents
