Table of Contents
Advertisement
Figure 55 Removing the mounting brackets from the chassis
3.
Put the mounting brackets into the box.
Removing the cable management bracket
1.
Prepare the packing box of the cable management bracket. Make sure the box is clean, dry, and
not damaged.
2.
Use a screwdriver to loosen the screws that attach the cable management bracket to the chassis,
and then remove the cable management bracket.
3.
Put the cable management bracket into the box.
Figure 56 Removing the cable management bracket from the chassis
Repackaging the switch chassis
1.
As shown in
brackets on the pallet base of the wooden carton.
Figure
57, align the screw holes on the two sides of the chassis bottom to the L-type
100
Advertisement
Table of Contents
Troubleshooting
