System Connection - Renishaw T101 Installation Manual

System connection

Approved ESD precautions must be followed at
all times during readhead and interface electrical
connections. The readhead is connected to the
Ti/TD interface via a small, rugged connector to
allow for easy feed-through during installation.
Connecting the readhead
1 Remove the cover plate as shown
(2 x M2.5 hex head screws).
2
Taking care not to touch the pins, plug the
connector into the socket in the interface,
ensuring correct orientation as shown.
3 Refit the cover plate ensuring the cable ferrule is located in the recess on the inside and no wires are trapped under the cover plate.
TONiC RSLM/RELM installation guide
Disconnecting the readhead
1 Remove the cover plate on the interface
(2 x M2.5 hex head screws).
2
Gently lever the connector PCB
(on the end of the cable) out of
the socket.
Do not pull the cable to remove
the connector.
3 Place the connector in an anti-static bag.
4 Refit the cover plate.
10