Clip/Clamp Mounting Installation - Renishaw T101 Installation Manual

Clip/clamp mounting installation

1
Thoroughly clean and degrease
the substrate with a
lint-free cloth.
Clean underside of scale using approved solvents
(see 'Storage and handling').
3 Fit remaining clips using clip setting shim M-9584-0928
(provided with A-9584-2050 clamp set).
TONiC RSLM/RELM installation guide
2
Fit clips on one side of scale and align to the specification given in the installation drawing.
Only the special low-profile screws supplied with the clips should be used.
Additional screws can be purchased from Renishaw (A-9584-2047 pack of 25).
NOTE: When mounting scale to vertical surfaces, temporary bridge clamps
(A-9584-2112) are available which support the scale prior to fitting clips.
Torque 0.5 Nm
4 Place datum clamps against scale and secure using the
special M3 low-profile screws supplied.
Torque 0.5 Nm
Clean scale
5
8