Autoanswer With Headset Or Speakerphone - Cisco DX600 series User Manual

Calling Tasks

AutoAnswer with Headset or Speakerphone

When AutoAnswer is enabled, your phone answers incoming calls automatically after a few rings. Your
system administrator configures AutoAnswer to use either the speakerphone or a headset. You may want to
use AutoAnswer if you receive a high volume of incoming calls.
If you...
Use AutoAnswer
with a headset
Use AutoAnswer
with the
speakerphone
AutoAnswer is disabled when the Do Not Disturb feature is active.
Note
Disconnect Call
To end a call, simply hang up. The following table provides more details.
If you want to...
Hang up while using the handset
Hang up while using a headset
Hang up while using the speakerphone
Hang up one call, but preserve another call
on the same line
OL-28931-01
Then...
Keep headset mode active (in other words, keep
a call.
To keep headset mode active, perform the following actions:
• Press EndCall to hang up.
• Press New Call or Dial to place new calls.
If your phone is set up to use AutoAnswer in headset mode, calls are automatically
answered only if is lit.
Otherwise, calls ring normally and you must answer them manually.
Keep the handset in the cradle and headset mode inactive (
Otherwise, calls ring normally and you must answer them manually.
Then...
Return the handset to the cradle. Or, press
Press
If you are using a wireless headset, refer to the wireless headset
documentation for instructions.
Press
Press
from hold first.
Cisco Desktop Collaboration Experience DX600 Series User Guide, Release 10.0(1)
lit), even when you are not on
. Or, to keep headset mode active, press
orpress .
. If necessary, remove the call that you want to end
Disconnect Call
unlit).
.
.
7