Table of Contents
Advertisement
Swap Camera Views
Swap Camera Views
Procedure
Step 1
Tap More.
Step 2
Tap Swap to switch between the internal and external cameras.
Headset
You can use a wired headset with your phone. You can also use a wireless headset with the wireless headset
remote hookswitch control feature.
You can use a headset with all the controls on your phone, including
However, if you use a wireless headset, refer to the wireless headset documentation for instructions.
If you want to...
Toggle headset mode on and off
Switch to a handset
Adjust the volume level for a call
If you use AutoAnswer, see
Headset Support
Although Cisco performs limited internal testing of third-party headsets for use with the Cisco DX650, Cisco
does not certify or support products from headset (or handset) vendors.
Cisco recommends the use of good-quality headsets that are screened against unwanted radio frequency (RF)
and audio frequency (AF) signals. Depending on the quality of the headsets and their proximity to other
devices such as mobile phones and two-way radios, some audio noise or echo may still occur. An audible
hum or buzz may be heard by either the remote party or by both you and the remote party. A range of outside
sources can cause humming or buzzing sounds : for example, electric lights, electric motors, or large PC
monitors.
In some cases, use of a local power cube or power injector may reduce or eliminate hum.
Note
Because of the environmental and hardware inconsistencies in the locations where phones are deployed no
single headset solution is optimal for all environments.
Cisco Desktop Collaboration Experience DX600 Series User Guide, Release 10.0(1)
106
Then...
Press
.
Lift the handset.
Press
AutoAnswer with Headset or Speakerphone, on page
and
during a call or after invoking a dial tone.
7.
Accessories
.
OL-28931-01
Advertisement
Table of Contents
