Pairing With A Bluetooth Headset - Cisco Webex DX70 User Manual

Introduction

Pairing with a Bluetooth Headset

Bluetooth Headsets
Bluetooth headset is supported on DX70 and DX80.
Bluetooth profiles supported:
HFP (Hands-Free Profile)
•
A2DP (Advanced Audio Distribution Profile)
•
Bluetooth headset is supported directly with the
embedded Bluetooth radio or by using a USB Bluetooth
dongle.
Multiple headsets can be paired with the video system,
but only one can be connected at a time.
The range is up to 10 m (30 ft). If you move outside the
range when in a call, the audio will switch to the speakers
on the video system.
Most headsets have built-in volume controls. When in
a call, the volume of the headset and video system is
synchronized. When not in a call, the volume buttons on
the headset and video system operate independently.
Supported Bluetooth features:
Answer incoming calls
•
Reject incoming calls
•
Hang up calls
•
Volume up and down
•
Some headsets have mute control. This operates
independently from the mute control on the video system.
D1510422 User Guide
Cisco Webex DX70, DX80
Produced: September 2018 for CE9.5
All contents © 2010–2018
Cisco Systems, Inc. All rights reserved
USB Bluetooth Dongle
Using a USB Bluetooth dongle is recommended, as it gives
better audio quality. When using the dongle the headset is
detected as a USB headset.
Note that there will be no synchronization of headset
volume and video system volume when using a dongle.
We have tested Jabra Link 360, Plantronics BT300 and
Plantronics BT600; though others may work as well.
To start pairing tap
Settings, in which menu
you will find Bluetooth
settings listed.
Pairing a Bluetooth Headset
1. Activate Bluetooth pairing on the headset. If in doubt,
consult the instruction manual for the headset.
2. Go to the Settings as explained at lower left. For more
on the System information menu, see
page
is enabled by default.
3. The video system will scan for devices. Upon successful
discovery the Bluetooth headset should be displayed in
the device list.
4. Select the device and pairing begins. It may take a few
seconds for the pairing to complete.
5. If the pairing is successful the video system will now
list the headset as connected. The pairing is then
completed.
You can switch between the speaker of the video system
and the devices connected via Bluetooth or USB.
Select the icon in the status bar of the user interface, and
choose from the available devices:
Icon appears
here
6
"Settings" on
38. If Bluetooth is disabled, turn it on. Bluetooth
Speakers
Analog headset (DX70 only)
USB headset
USB handset
Bluetooth device
You may use Bluetooth
pairing directly to the
video system, or use
a USB dongle.